Foto de Proyector LED / Láser PT-RZ31K

Proyector LED / Láser PT-RZ31K

Power supply AC 200-240 V, 50/60 Hz; AC 100-200 V, 50/60 Hz (brightness is restricted with lower voltage)
Power consumption TBD
DLP™ chip Panel size 24.4 mm (0.96 in)
diagonal (16:10 aspect ratio)
Display method DLP™ chip x 3, DLP™ projection system
Pixels 2,304,000 (1,920 x 1,200) x 3,
total of 6,912,000 pixels
Refresh Rate 120 Hz*¹
Lens Optional powered zoom and fixed-focus lenses (no lens included with this model)
Light source Laser diodes
Screen size (diagonal) 1.78-25.4 m (70-1,000 in),
1.78-15.24 m (70-600 in)
with the ET-D75LE8,
3.05-15.24 m (120-600 in)
with the ET-D75LE95,
16:10 aspect ratio
Brightness 31,000 lm (Center) / 30,000 lm*² (High Mode)*³
Center-to-corner uniformity*² 90%
Contrast*² 20,000:1 (Full on/off, with Dynamic Contrast Mode set to “3” )
Resolution 1,920 x 1,200 pixels
Scanning 
frequency
SDI SD-SDI SMPTE ST 259 compliant, [YCBCR 4:2:2 10-bit] 480i, 576i
HD-SDI SMPTE ST 292 compliant, [YPBPR 4:2:2 10-bit] 720/60p, 720/50p, 1080/60i, 1080/50i, 1080/25p, 1080/24p, 1080/24sF, 1080/30p
Dual-link
HD-SDI
SMPTE ST 372 compliant, [RGB 4:4:4 12-bit /10-bit] 1080/60i, 1080/50i, 1080/25p, 1080/24p, 1080/24sF, 1080/30p, 2048 x 1080/24p, 2048 x 1080/25p, 2048 x 1080/30p, [X´Y´Z´ 4:4:4 12-bit] 2048 x 1080/24p, 2048 x 1080/25p, 2048 x 1080/30p
3G-SDI SMPTE ST 424 compliant, [RGB 4:4:4 12-bit/10-bit] 1080/60i, 1080/50i, 1080/25p,  1080/24p, 1080/24sF, 1080/30p, 2048 x 1080/24p, 2048 x 1080/25p, 2048 x 1080/30p,  [YPBPR 4:2:2 10-bit] 1080/60p, 1080/50p, 2048 x 1080/48p, 2048 x 1080/50p, 2048 x 1080/60p,  [X'Y'Z' 4:4:4 12-bit] 2048 x 1080/24p, 2048 x 1080/25p, 2048 x 1080/30p
Dual-link
3G-SDI
SMPTE ST 425 compliant, [YPBPR 4:4:4 12-bit / 10-bit] 1080/60p, 1080/50p, 2048 x 1080/60p, 2048 x 1080/50p, 2048 x 1080/48p, [RGB 4:4:4 12-bit/10-bit] 1080/60p, 1080/50p, 2048 x 1080/60p, 2048 x 1080/50p, 2048 x 1080/48p
HDMI/DVI-D/DIGITAL LINK Compatible with HDCP, 480i*⁴, 576i*⁴, 480p, 576p, 720/60p, 720/50p, 1080/60i, 1080/50i, 1080/24p, 1080/24sF, 1080/25p, 1080/30p, 1080/60p, 1080/50p, 640 x 400-WUXGA*⁵ (1920 x 1200) (compatible with non-interlaced signals only), dot clock: 25-162 MHz
RGB fH: 15-100 kHz, fV: 24-120 Hz, dot clock: 20-162 MHz or lower
YPBPR (YCBCR) fH: 15.73 kHz, fV: 59.94 Hz [480i (525i)],
fH: 31.47 kHz, fV: 59.94 Hz [480p (525p)],
fH: 45.00 kHz, fV: 60 Hz [720 (750)/60p],
fH: 33.75 kHz, fV: 60 Hz [1080 (1125)/60i],
fH: 27.00 kHz, fV: 24 Hz [1080 (1125)/24p],
fH: 28.13 kHz, fV: 25 Hz [1080 (1125)/25p],
fH: 67.50 kHz, fV: 60 Hz [1080 (1125)/60p],
fH: 15.63 kHz, fV: 50 Hz [576i (625i)],
fH: 31.25 kHz, fV: 50 Hz [576p (625p)],
fH: 37.50 kHz, fV: 50 Hz [720 (750)/50p],
fH: 28.13 kHz, fV: 50 Hz [1080 (1125)/50i],
fH: 27.00 kHz, fV: 48 Hz [1080 (1125)/24sF],
fH: 33.75 kHz, fV: 30 Hz [1080 (1125)/30p],
fH: 56.25 kHz, fV: 50 Hz [1080 (1125)/50p]
Video/Y/C fH: 15.73 kHz, fV: 59.94 Hz [NTSC/NTSC4.43/PAL-M/PAL60],
fH: 15.63 kHz, fV: 50 Hz [PAL/PAL-N/SECAM]
Optical axis shift*⁶
(from center of screen)
Vertical ±55 % (±44 % with the ET-D75LE6,
+68 - +78 % with the ET-D75LE95) (powered)
Horizontal ±20 % (±15 % with the ET-D75LE6,
±12 % with the ET-D75LE95) (powered)
Keystone correction range Vertical : ±40° (±22° with the ET-D75LE50, ±28° with the ET-D75LE6,
horizontal: ±15°
Keystone correction range with
optional upgrade kit (ET-UK20)
Vertical: ±45° (±40° with the ET-D75LE10/ET-D75LE20,
±22° with the ET-D75LE50, ±28° with the ET-D75LE6),
horizontal: ±40° (±15° with the ET-D75LE50/ET-D75LE6), 
Up to a total of ±55 ° during simultaneous horizontal and vertical correction.
Installation Ceiling/floor, front /rear, free 360-degree installation
Terminals SDI 1 IN BNC x 1 (3G/HD/SD-SDI input, Dual-link HD-SDI (LINK-A), Dual-link 3G-SDI (LINK 1))
SDI 2 IN BNC x 1 (3G/HD/SD-SDI input, Dual-link HD-SDI (LINK-B), Dual-link 3G-SDI (LINK 2))
HDMI IN HDMI 19-pin x 1 (Deep Color, compatible with HDCP)
DVI-D IN DVI-D 24-pin x 1 (DVI 1.0 compliant, compatible with HDCP)
RGB 1 IN BNC x 5 (RGB/YPBPR/YCBCR/YC/VIDEO x 1)
RGB 2 IN D-Sub HD 15-pin (female) x 1 (RGB/YPBPR x 1)
SYNC 1 IN/OUT / MULTI PROJECTOR SYNC IN BNC x 1
SYNC 2 OUT / MULTI PROJECTOR SYNC OUT BNC x 1
SERIAL IN D-sub 9-pin (female) x 1 for external control (RS-232C compliant)
SERIAL OUT D-sub 9-pin (male) x 1 for link control
REMOTE 1 IN / OUT M3 x 1 for wired remote control, link control
REMOTE 2 IN D-sub 9-pin (female) x 1 for external control (parallel)
LAN/DIGITAL LINK RJ-45 x 1 (for network, DIGITAL LINK connection, 100Base-TX,
compatible with Art-Net, PJLink™ (class 1), Deep Color, HDCP)
DC OUT USB Type A x 2 for power supply (DC 5 V, max 900 mA)
Cabinet materials Metal (Partly molded plastic)
Dimensions (W x H x D) 706 x 420 x 1,290 mm (27-25/32 x 16-17/32 x 50-25/32 in) (with protrusion parts)
Weight*⁷ Approx. 79 kg (174 lbs.)
Operation noise*² TBD
Operating environment Operating temperature: 0-45°C (32-113°F)*⁸,
operating humidity: 10- 80 % (no condensation)
Applicable software Logo Transfer Software, Multi Monitoring & Control Software, Early Warning Software, Geometry Manager Pro (ET-UK20 Upgrade Kit, Smart PJ Control)
Notes: *1 Refresh-rate varies depending on vertical scanning frequency.
*2 Measurement, measuring conditions, and method of notation all comply with ISO 21118 international standards.
*3 Operation in High Mode may reduce maintenance timing in comparison to use in Normal Mode.
*4 Only compatible with dot clock frequency of 27 MHz (pixel repetition signal).
*5 WUXGA resolution is supported only when the signals are compliant with VESA CVT-RB (Coordinated Video Timing-Reduced Blanking).
*6 Optical axis shift is not supported on the ET-D75LE50.
*7 Average value. May differ depending on the actual unit.
*8 When projector is operating at high attitude (1,400-2,700 m) [4,593-8,858 ft], operating temperature is 0-40 °C (32-104 °F). Light source brightness may decrease depending on operating temperature. When projector is operating at high temperature or at high altitude, brightness will decrease correspondingly.